New Products for May

[JMFabrications]

Hello,


I’d like to start off by thanking all of you for your support and continued sales. We have been very busy the past few months and have a bunch of new things to show for it. First up:

DSM Stuff
1G Bolt In Fuel Cell

http://www.jmfabrications.com/catalo...roducts_id=295

DSM Top Mount T4 Exhaust Manifold

http://www.jmfabrications.com/catalo...roducts_id=290

1G TB to Q45 TB Adapter plate (For use with our intake manifold)

http://www.jmfabrications.com/catalo...roducts_id=297

1G TB to Accufab TB Adapter plate (For use with our intake manifold)

http://www.jmfabrications.com/catalo...roducts_id=298

1G TB to Power Plus/BBK TB Adapter plate (For use with our intake manifold)

http://www.jmfabrications.com/catalo...roducts_id=296


EVO 7/8/9 Stuff
In the past our upper IC piping kit had only worked with our sheetmetal intake or other sheetmetals that sat low, we now have one available for the stock intake manifold located on the same catalog page
http://www.jmfabrications.com/catalo...roducts_id=275

EVO O2 Housing w/ Internal Dump

http://www.jmfabrications.com/catalo...roducts_id=288

EVO O2 Housing w/ External Dump

http://www.jmfabrications.com/catalo...roducts_id=287

EVO Twin Scroll Exhaust Manifold

http://www.jmfabrications.com/catalo...roducts_id=289

EVO “Drag Version” Intake Manifold

http://www.jmfabrications.com/catalo...roducts_id=293

EVO 10 Stuff
EVO X SS Heatshield

http://www.jmfabrications.com/catalo...roducts_id=291

EVO X MAF Flange

http://www.jmfabrications.com/catalo...roducts_id=292


Flanges
We added a bunch of new stainless steel & aluminum flanges under the DIY section which include:
http://www.jmfabrications.com/catalo...hp?cPath=27_30

4G63 Exhaust Manifold


DSM 1” TB Spacer


T3 Inlet


Divided T3 Inlet


T4 Inlet


Divided T4 Inlet


6-bolt T3 Outlet


Keep in mind we do most CNC machining in house, if you don’t see a flange needed chances are we can make it quickly!

A few quick product updates:
1. Our 1G FIAV bypass and blockoff plates will work on the 2G
2. We changed the massive logo on our drag version intake manifolds to a much smaller sleeker looking logo which can be seen in the pictures of the EVO Drag Manifold


That’s all for now, many more products are in the works and will be released soon.

Thanks again,
Jim McKeone


JM Fabrications LLC
Motorsports Welding & Design
2700 Bergey Rd. BLDG F
Hatfield, PA 19440
Office: 215-703-3721
Fax: 215-660-4958
www.jmfabrications.com

[06evors]

You guys do some quality work for sure. I would love to get the o2 w/ the dump but can't deal with all the extra noise. Cause and effect is a bitch.