shop to cut and reweld intake manifold? - TriStateTuners.com :: Home of Tristate Auto Enthusiast

rocknrace03 · 09-13-2011, 08:34 PM

I'm working on my 73 volvo with the turbo motor swap, throttle body hits the steering shaft, need to have the manifold cut and rewelded at the correct angle, not looking to spend a ton, but i understand that tig welding is tedious and a skill that is not always readily available, any vendors do this?, i live near allentown pa, i think the manifold is cast aluminum. i would probably need it cut first and then take it home to determine the correct angle maybe take some pictures and bring it back
thanks! ~Joey

**dangerousatom** · 09-13-2011, 09:46 PM

JM Fab
RT Tunning
AREA1320

09-13-2011, 08:34 PM	#1
rocknrace03 Tri-State Post Whore Join Date: Sep 2010 Location: Schnecksville Pa Member #17593 My Ride: WRX iTrader: (2)	shop to cut and reweld intake manifold? I'm working on my 73 volvo with the turbo motor swap, throttle body hits the steering shaft, need to have the manifold cut and rewelded at the correct angle, not looking to spend a ton, but i understand that tig welding is tedious and a skill that is not always readily available, any vendors do this?, i live near allentown pa, i think the manifold is cast aluminum. i would probably need it cut first and then take it home to determine the correct angle maybe take some pictures and bring it back thanks! ~Joey Last edited by rocknrace03; 09-13-2011 at 08:43 PM.

09-13-2011, 09:46 PM	#2
dangerousatom [TST] Calendar Master Join Date: Jul 2005 Location: Q-town/AREA1320 Member #625 My Ride: 02-04 RS-STi @391whp 02-WRX Wagon @310whp ≈≈≈ Both modded to the hilt w/PPG trans iTrader: (5)	JM Fab RT Tunning AREA1320 __________________ 02-04 RS-STi build /swap To view links or images in signatures your post count must be 10 or greater. You currently have 0 signatures. To view links or images in signatures your post count must be 10 or greater. You currently have 0 signatures. 02 WRX Wagon Beater-10/01/11 To view links or images in signatures your post count must be 10 or greater. You currently have 0 signatures.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
JDM V7 intake manifold!	JDMgoodness	(Past Vendors)	6	10-25-2007 12:08 PM
machine shop to port a srt-4 intake manifold	05OCsrt-4	Engine Performance	7	12-22-2005 12:54 AM