TriStateTuners.com :: Home of Tristate Auto Enthusiast  

Go Back TriStateTuners.com :: Home of Tristate Auto Enthusiast > Community > General Car Related Chat
Register Rules & Info

Notices

Reply
 
Thread Tools Display Modes
Old 11-07-2010, 02:29 PM   #1
zuki19
Tri-State Addict
 
zuki19's Avatar
 
Join Date: Mar 2008
Location: Lancaster, PA
Member #7163

My Ride:
1999 Turbo Grand AM GT

iTrader: (0)
Rich on idle, lean in boost

Really thrown off here... my wideband is telling me car is running fine, than all a sudden i get random issues with my car going really rich... and when i boost it fixes itself than starts goign to like 12.2-12.4 on only 5 psi, breaks up terribly even when cruising its like there is a limiter around 2500-2800 rpms right when turbo would kick it and even when my PE isnt even kicking in or spooling.

Only new mods that i really put on because i have yet to send my top end out and order forged pistons would be aeromotive fpr, ls6 valve springs, - racetronix fuel pump not installed.

and friend was behind me and said my car smells really rich but my wideband could be reading 14:6-14:8.

I've came to conclusion:
Failing PCM
Vaccum Leak somewhere (BOV is hooked up but stopped working? maybe its stuck open ill have to spray it again...)
Failing Fuel Pump/relay?
Spark Plugs/Wires? (very rough idle at a cold start than settles down. Sounds cammed)
I also eat spark plugs up liek crazy when i raise my timing to point where its just enough to be safe and not get any KR.
I use NGK TR6 Copper cores with MSD Ign Oversized wires.
I noticed if i drive for awhile, than try starting my car, it will refuse to start also, never had this issue since i changed my head gaskets and replaced valve springs with stiffer springs like above
zuki19 is offline   Reply With Quote
Old 11-07-2010, 02:37 PM   #2
Got Insulin?
Hard Snarker
Super Moderator
 
Got Insulin?'s Avatar
 
Join Date: Apr 2008
Location: Philly
Member #7591

My Ride:
01 Audi TT 225, GVR-4 #72/1000, 91 TSi AWD

iTrader: (16)
Send a message via AIM to Got Insulin?
Definately start out with a boost leak check, then move on from there: Did you adjust the FPR to where you want it for adequate fuel pressure? Is your fuel pressure consistent? What fuel pump are you using now, the stock one?

What do you mean that your BOV stopped working? That throws a flag because it'd essencially be a huge boost leak which would cause whatever is metering your airflow, MAF I think in your car, to freak out.
__________________
-Taylor
DenOfDebauchery
Got Insulin? is offline   Reply With Quote
Old 11-07-2010, 02:38 PM   #3
zuki19
Tri-State Addict
 
zuki19's Avatar
 
Join Date: Mar 2008
Location: Lancaster, PA
Member #7163

My Ride:
1999 Turbo Grand AM GT

iTrader: (0)
Boost leak as in a header leak? or cold side? and not really I didnt adjust it much, I still need to order a electronic fuel pressure gauge will make it easier to read. and for the BOV, it just doesnt work... vaccum lines are hooked up properly all you can hear is my wastegate opening and closing, sounds sick though

What would shop costs usually charge for build and dyno tune? I have a whole new top end to put in and stage 3 turbo cam but mostly would rather them touch my bottom end because I dont have the proper tools for that or the garage.

Last edited by zuki19; 11-07-2010 at 02:45 PM.
zuki19 is offline   Reply With Quote
Old 11-07-2010, 03:04 PM   #4
JankyS13
Tri-State Post Whore
Banned
 
Join Date: Dec 2009
Member #15373

My Ride:
91.S13.KA-T

iTrader: (1)
Quote:
Originally Posted by zuki19 View Post
Boost leak as in a header leak? or cold side? and not really I didnt adjust it much, I still need to order a electronic fuel pressure gauge will make it easier to read. and for the BOV, it just doesnt work... vaccum lines are hooked up properly all you can hear is my wastegate opening and closing, sounds sick though

What would shop costs usually charge for build and dyno tune? I have a whole new top end to put in and stage 3 turbo cam but mostly would rather them touch my bottom end because I dont have the proper tools for that or the garage.
boost leaks, check all the couplers, manifolds and so on. you know everything in the line. I found that a spray bottle w/ soapy water helps in this matter too. but also double check your piping make sure none of it has rubbed up against something and created a small nick some where.

sounds like the bov might need to be adjusted, so it releases easier / sooner, had the same issue w/ mine when i first put it on. key note flutters are bad. can give you thrust play on your turbo.
JankyS13 is offline   Reply With Quote
Old 11-07-2010, 03:15 PM   #5
zuki19
Tri-State Addict
 
zuki19's Avatar
 
Join Date: Mar 2008
Location: Lancaster, PA
Member #7163

My Ride:
1999 Turbo Grand AM GT

iTrader: (0)
Well I have had an issue with my IC piping rubbing, I wrapped the **** out of it after I welded it closed. But I do have a bad header leak right now in the back... tick tick tick is all I hear, but whats with the turboXS boost controllers, I have 3 of them all of them leak air through the adjustment screw, this is not normal? IMO they are junk, guess ill buy a new one any ideas on what i should get, how are electronic ones?
zuki19 is offline   Reply With Quote
Old 11-07-2010, 03:25 PM   #6
JankyS13
Tri-State Post Whore
Banned
 
Join Date: Dec 2009
Member #15373

My Ride:
91.S13.KA-T

iTrader: (1)
Quote:
Originally Posted by zuki19 View Post
Well I have had an issue with my IC piping rubbing, I wrapped the **** out of it after I welded it closed. But I do have a bad header leak right now in the back... tick tick tick is all I hear, but whats with the turboXS boost controllers, I have 3 of them all of them leak air through the adjustment screw, this is not normal? IMO they are junk, guess ill buy a new one any ideas on what i should get, how are electronic ones?
i personally like manual boost controllers halman pros ftw.

and look at it like this a boost leak is a boost leak it needs to be an air tight system. even tho you have fixed and wrapped that leak i would also check it agian and see if theres a way to make the hole bigger yo.
JankyS13 is offline   Reply With Quote
Old 11-07-2010, 07:48 PM   #7
supraghost
Tri-State Post Whore
 
supraghost's Avatar
 
Join Date: Mar 2008
Location: Marietta, PA
Member #7051

My Ride:
2002 5mt IS300, 1995 s14

iTrader: (3)
Send a message via AIM to supraghost
usually a boost leak is lean on idle and rich on boost.

unless you are leaking post maf preturbo.
__________________
Quote:
theres no computer in the kitchen...how are they updating facebook status's?

'92 festiva: BP 1.8l DOHC, garret gt2554r, mostly stock otherwise


To view links or images in signatures your post count must be 10 or greater. You currently have 0 signatures.
supraghost is offline   Reply With Quote
Old 11-08-2010, 04:32 PM   #8
zuki19
Tri-State Addict
 
zuki19's Avatar
 
Join Date: Mar 2008
Location: Lancaster, PA
Member #7163

My Ride:
1999 Turbo Grand AM GT

iTrader: (0)
apparently i cannot connect to my pcm on my laptop to check to see what else is going on... possible pcm failure?
zuki19 is offline   Reply With Quote
Old 11-08-2010, 04:50 PM   #9
jpalamar
TST Ruined My Life!
 
jpalamar's Avatar
 
Join Date: May 2009
Location: Orefield, PA
Member #13773

My Ride:
'14 Mustang GT

iTrader: (3)
Quote:
Originally Posted by supraghost View Post
unless you are leaking post maf preturbo.
I would think he would be running a SD tune only. If I went FI in the GTO, I would kill off the MAF.

If your not able to rev past 3000 or 3500 MAP sensor could be the cause. Also def do a boost leak test. Are you using HP Tuners and it won't sync with your car?
__________________
2014 Mustang GT performance package, M6, Brembo brakes, Torsen diff with 3.73, Steeda CAI with 101mm MAF, ST coilovers with caster/camber plates, BMR lower control arms, BMR watts link, BMW sway bars with end links, front brake cooling ducts, SR short shiffter, and custom tuned

Last edited by jpalamar; 11-09-2010 at 12:36 PM.
jpalamar is offline   Reply With Quote
Old 11-09-2010, 12:33 PM   #10
DPancoast
TST Ruined My Life!
 
DPancoast's Avatar
 
Join Date: Nov 2007
Member #6193

My Ride:
94 Integra GSR / 96 Jeep (DD)

iTrader: (6)
Send a message via AIM to DPancoast
so many things it could be lol

the breakup could be due to a boost leak, an ignition issue, or even possibly timing.

a faulty bov is def not helping the issue(s) thats for sure.
__________________
Dan

- 94 Integra "Panda" GSR/LS (crashed to finished in < 30 days)
- 96 Integra (Totaled 5/28/2011)
- 91 MR2 Turbo (SOLD)
- 91 MR2 n/a (SOLD)

Quote:
in-raging? is that like an internal raging hard on? usage might include: i'm in-raging for some bacon right now
DPancoast is offline   Reply With Quote
Old 11-10-2010, 01:41 PM   #11
SovXietday
Tri-State Post Whore
 
SovXietday's Avatar
 
Join Date: Jan 2007
Location: Pennsyltuckey
Member #3403

My Ride:
Civic - CBR - Civic

iTrader: (0)
Send a message via AIM to SovXietday
It's a leak somewhere most likely. Something small, try pressurizing the system and checking for leaks that way.
__________________
Champ White 1996 Civic Hatch -
To view links or images in signatures your post count must be 10 or greater. You currently have 0 signatures.


Quote:
Relax, bud. When the dude with a drag Honda and a boosted daily that has had fast Honda's for years AND fabs his own parts tells the new kids on the block that they're doing it wrong, it's time to step back and learn something.
SovXietday is offline   Reply With Quote
Old 11-10-2010, 10:27 PM   #12
skalor
Tri-State Training Wheels
 
skalor's Avatar
 
Join Date: Feb 2008
Member #7020

My Ride:
I don't know, my grandfather gave it to me.

iTrader: (0)
So you can't connect to the PCM?? If you get it to connect and have HP Tuners, post a scan and I'll take a look at it.
__________________
'89 Oldsmopile - 413 whp...meh
'04 Comp G - stock
skalor is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
rough idle, Sometimes acts like it dont want to start! running rich all cylinders franwake13 Mitsubishi Talk 2 04-28-2010 09:48 AM
Car Runs pig rich/ stalls at idle. JSpecV03 Engine Management and Tuning 25 12-10-2009 02:14 AM
VW- 95 2.0 Randomly stumbles at idle. between 800-1100 RPM's. Idle Control Valve? Drftpretty Engine Performance 0 03-15-2008 04:53 PM
how to tell if runninr rich or lean? sleepersatty99 General Car Related Chat 9 05-18-2007 05:34 PM
Idle Issues (No longer holds idle) naDintheHat Audi / Volkswagen Talk 8 03-22-2007 01:24 PM


All times are GMT -4. The time now is 07:42 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.