2step in parking garage.

[blackvr4]

turn up the volume! lol

http://www.youtube.com/watch?v=cgafDG3_L1A

[redline]

Sounds good but was that long enough to boost?

[Crzyguy972]

damn sounds awsome wehre that at

[blackvr4]

somewhere in voorhese,

and yea i saw about 15psi at redline in 1st gear.

[teh DIRT]

seems like it bogged tho?

[redline]

Originally Posted by teh DIRT

seems like it bogged tho?

Yeah I dont think you were boosting while sitting still.

[blackvr4]

it doesnt boost anymore while 2stepping. i like it better that way, because on the old set up it would boost and all it would do is spin all 4 at the launch, i only have launched 4 times now on this set up, im still gettin used to it. its wierd from going from spinning all 4rs to not spinning.

[redline]

Originally Posted by blackvr4

it doesnt boost anymore while 2stepping. i like it better that way, because on the old set up it would boost and all it would do is spin all 4 at the launch, i only have launched 4 times now on this set up, im still gettin used to it. its wierd from going from spinning all 4rs to not spinning.

To be honest, I would think there is no way it is faster this way and would cut a lower 60'. Try holding it a couple seconds and eye the gauge, it should show boost.

[blackvr4]

Originally Posted by redline

To be honest, I would think there is no way it is faster this way and would cut a lower 60'. Try holding it a couple seconds and eye the gauge, it should show boost.

ive driven the car on the old turbos and it is noticably faster this way, with the old set up all it would do is spin all 4rs and id either have to let off the gas and get back on it or stay on the gas and keep spinning and get sideways, almost crashed into my friends car because i stayed on it thinking that it would correct itself and go forward.

i dont know if u are familiar with how an MSD dis 4 system works, but all it does is drop spark to each cylender, it isnt like the anti lag system for the DSMs, as in DSMlink or AEM. on my old set up using dr650s which are way smaller turbos i could spool up about 4-5psi bouncing off, with this set up it just stays at 0, not matter how long u bounce on the 2 step due to the fact that these turbos are much much larger, and id need an AEM to really make it spool but then all id have is wheel spin or a slipping clutch if i slip it. thats how it was on the old set up, it was either spin all 4rs or clutch would slip in 1st and 2nd if i feathered it.

plus on the old set up pre 2step funtion i could consistantly pull 1.8s and a couple 1.7s the way i see it if i can just pull 1.7s more consistanly with a 2 step and just improve on the top end with a larger turbo set up, i dont need a 1.5 sixty foot or anything like that, plus with these cars only a handful of people even pulled 1.6s, so im content with even a 1.8