![]() |
Rich on idle, lean in boost
Really thrown off here... my wideband is telling me car is running fine, than all a sudden i get random issues with my car going really rich... and when i boost it fixes itself than starts goign to like 12.2-12.4 on only 5 psi, breaks up terribly even when cruising its like there is a limiter around 2500-2800 rpms right when turbo would kick it and even when my PE isnt even kicking in or spooling.
Only new mods that i really put on because i have yet to send my top end out and order forged pistons would be aeromotive fpr, ls6 valve springs, - racetronix fuel pump not installed. and friend was behind me and said my car smells really rich but my wideband could be reading 14:6-14:8. I've came to conclusion: Failing PCM Vaccum Leak somewhere (BOV is hooked up but stopped working? maybe its stuck open ill have to spray it again...) Failing Fuel Pump/relay? Spark Plugs/Wires? (very rough idle at a cold start than settles down. Sounds cammed) I also eat spark plugs up liek crazy when i raise my timing to point where its just enough to be safe and not get any KR. I use NGK TR6 Copper cores with MSD Ign Oversized wires. I noticed if i drive for awhile, than try starting my car, it will refuse to start also, never had this issue since i changed my head gaskets and replaced valve springs with stiffer springs like above |
Definately start out with a boost leak check, then move on from there: Did you adjust the FPR to where you want it for adequate fuel pressure? Is your fuel pressure consistent? What fuel pump are you using now, the stock one?
What do you mean that your BOV stopped working? That throws a flag because it'd essencially be a huge boost leak which would cause whatever is metering your airflow, MAF I think in your car, to freak out. |
Boost leak as in a header leak? or cold side? and not really I didnt adjust it much, I still need to order a electronic fuel pressure gauge will make it easier to read. and for the BOV, it just doesnt work... vaccum lines are hooked up properly all you can hear is my wastegate opening and closing, sounds sick though
What would shop costs usually charge for build and dyno tune? I have a whole new top end to put in and stage 3 turbo cam but mostly would rather them touch my bottom end because I dont have the proper tools for that or the garage. |
Quote:
sounds like the bov might need to be adjusted, so it releases easier / sooner, had the same issue w/ mine when i first put it on. key note flutters are bad. can give you thrust play on your turbo. |
Well I have had an issue with my IC piping rubbing, I wrapped the **** out of it after I welded it closed. But I do have a bad header leak right now in the back... tick tick tick is all I hear, but whats with the turboXS boost controllers, I have 3 of them all of them leak air through the adjustment screw, this is not normal? IMO they are junk, guess ill buy a new one any ideas on what i should get, how are electronic ones?
|
Quote:
and look at it like this a boost leak is a boost leak it needs to be an air tight system. even tho you have fixed and wrapped that leak i would also check it agian and see if theres a way to make the hole bigger yo. |
usually a boost leak is lean on idle and rich on boost.
unless you are leaking post maf preturbo. |
apparently i cannot connect to my pcm on my laptop to check to see what else is going on... possible pcm failure?
|
Quote:
If your not able to rev past 3000 or 3500 MAP sensor could be the cause. Also def do a boost leak test. Are you using HP Tuners and it won't sync with your car? |
so many things it could be lol
the breakup could be due to a boost leak, an ignition issue, or even possibly timing. a faulty bov is def not helping the issue(s) thats for sure. |
It's a leak somewhere most likely. Something small, try pressurizing the system and checking for leaks that way.
|
So you can't connect to the PCM?? If you get it to connect and have HP Tuners, post a scan and I'll take a look at it.
|
| All times are GMT -4. The time now is 08:01 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.