D16z6 Map Sensor problem..

[JDMTyler3326]

I recently got my crx with a blown head gasket turned out to be blown motor so I swapped another d16z6 into. Same year and same obd. Only problem I have is, I think the old motor was tunned without a map sensor because I can't find it on my harness. My question is you think its safe to block off my map sensor and just get it tuned again?

[igo4bmx]

you will need the map sensor hooked up since the stock ecu will need vacuum readings

[igo4bmx]

make sure you didn't mix MAP and I think IACV? I forget (its been a while) but I believe those two have the same harness clip design.

[JDMTyler3326]

make sure you didn't mix MAP and I think IACV? I forget (its been a while) but I believe those two have the same harness clip design.

Is that the IACV the other one on the back of the mani? If so I was thinking about that today and I am gonna check tomorrow.

[saxon]

some map sensors for d16z6's were mounted on the firewall (not on the tb)