GSR P72 Race Head!!

[bcspeed215]

P72 OBD1 GSR HEAD
Race port and polish by Lorenzos Fast Flow Cylinder Heads
Back cut valve guides
Multi angle valve job
Crower stainless steel valves .5mm oversized intake valves
Crower dual valve springs and titanium retainers
GSR Cams
Skunk 2 intake mainfold

Used for about 45 dyno pulls

This cylinder head was used on our 91 integra. It was used along with 81.5mm ITR block with JE pistons, Crower rods, Full-Race T3 bottom mount with a T67 H.O. turbo. The engine made 610whp with room for more power with added fuel. We are upgrading our setup on this car so I have opted to sell the head. We are looking to get 1650 with the Skunk 2 intake manifold or 1550 with a GSR intake manifold. Or Best Offer!