Bleeder valve - TriStateTuners.com :: Home of Tristate Auto Enthusiast

Erik · 02-26-2008, 09:12 AM

I just did the pads on a car i bought but i could not get the bleeder valves to turn at all when trying to bleed the brake system. Im not looking to buy calipers since they seem to be in decent condition. I sprayed WD-40 on them about three times each, about 10 minutes apart. They cleaned up pretty well but the metal seems to be too soft, the socket is stripping and the plyers' teeth are digging in. I dont want to mutilate the things. Any suggestions on what to do?

(1993 pontiac sunbird)

Kupop · 03-19-2008, 10:28 AM

I would try to put some heat on it with a torch, don't go too hot though.

No reason to use pliers, just the proper size 6 point socket.

02-26-2008, 09:12 AM	#1
Erik Tri-State Post Whore Join Date: May 2006 Location: Glenside, PA Member #1962 My Ride: 2001 Audi A6 2.7 Twin Turbo iTrader: (4)	Bleeder valve I just did the pads on a car i bought but i could not get the bleeder valves to turn at all when trying to bleed the brake system. Im not looking to buy calipers since they seem to be in decent condition. I sprayed WD-40 on them about three times each, about 10 minutes apart. They cleaned up pretty well but the metal seems to be too soft, the socket is stripping and the plyers' teeth are digging in. I dont want to mutilate the things. Any suggestions on what to do? (1993 pontiac sunbird) __________________ --Eric '96 Mazda Miata \| FM V-Maxx Coilovers \| Jackson Racing Exhaust/Intake GONE To view links or images in signatures your post count must be 10 or greater. You currently have 0 signatures. 01' Audi A6 2.7 Twin Turbo \| Daily \| NoMods

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need to borrow a vacuum bleeder tool, Philly	OutToWinPAHC	Networking: requests and offers	1	03-19-2010 09:09 PM
Reseller for Motive Power Bleeder and Gorilla Wheel Install Kit	GeforceXtreme	Networking: requests and offers	0	05-20-2009 02:47 PM
Valve tap	CleanNeon98	Honda / Acura Talk	28	02-28-2008 08:32 PM
Valve tap when cold...valve adjustment needed?	CleanNeon98	Honda / Acura Talk	6	10-10-2007 12:15 PM

03-19-2008, 10:28 AM	#2
Kupop Tri-State Aficionado Join Date: Oct 2005 Location: Weatherly, PA Member #999 My Ride: '06 Chevy TrailBlazer SS; '01 Subaru Impreza 2.5RS; '93 Toyota MR2-T iTrader: (3)	I would try to put some heat on it with a torch, don't go too hot though. No reason to use pliers, just the proper size 6 point socket.