Raced at Cecil Today

[TurboGSR96]

IT WAS FREEZING! It was also the first time I have ever attempted to use slicks, I have a dying clutch and torn pep-boys axles, but I made it down the track and made it back on the trailor without broke axles.

FIrst run I dont know if I hit fluid or ice or what, but I almost crossed the center line 3 or 4 times so I got out of it, was like a 12.6 @ 108 or something,

2nd and final run

60' 1.83

330' 4.91

1/8 7.30

MPH 102.71

1000' 9.346

1/4 11.011

MPH 136.87

The above time is not all its got, I should be able to cut another .20 off of my 60' with less air in the slicks and a track that isnt 33 degrees, and atleast another .10 off the 330' and that puts me in the mid 10's at around 500whp, I have another 80whp I can throw at it with Ethanol and another 100-150whp if I switch to Q16, then my injectors are maxed, as it was with this really cold air I was at 100% duty in my datalogs using E85, if I would of blended it down to E70 I could of got a little more out of it.


Got the boot on my 1st full pass, no cage or bar or anything

Short vid from my brothers cell phone, the Camaro ran a 1.78 60' and a 12.15 @ 116

http://www.youtube.com/watch?v=LWEUH...e=channel_page

[peteyturbo]

That car is moving OUT!! BTW the ethanol mixture in this area should be E70 right now anyway..Are you using 1600's???What fuel pump?

[TurboGSR96]

It should be E70 but its not, it took me 2 seconds to start my car last winter, it takes 10 right now. And my AFR's were about 1 point lean on my winter dyno/tune which was on E70 so I had to add 6-7% fuel trackside.

I am using 1000cc Injectors and 2 Walbro 255hp's and they were pretty close to being maxed out with the combination of the super cold air and the 85% Ethanol Mixture, 1600's shouldnt even be called Injectors they should be called nossles, there is no way to idle them without a misfire any leaner than 12.0, which is not very streetable IMO

I have seen flow charts of 1600's at idle, and literally the lowest than can flow is like 250-300cc's, which is a **** ton of fuel for an idleing vehicle.

[SvicksTc]

wow man crazy numbers for such cold weather and hella of a fast integra...You street that beast....Please more on the mods and specs.....

[HickRocket1258]

I don't think it would of been worth racing in the cold weather due to the fact that you can't get any traction with this cold weather. Especially with a fwd car. If you end up having to put a cage in there, you are going to be losing a couple tenths due to the weight factor when a cage goes in.

[TurboGSR96]

Originally Posted by HickRocket1258

I don't think it would of been worth racing in the cold weather due to the fact that you can't get any traction with this cold weather. Especially with a fwd car. If you end up having to put a cage in there, you are going to be losing a couple tenths due to the weight factor when a cage goes in.

The Cromoly Cage I have sitting in the garage only weights 50lbs, I am shedding that this winter by plugging the sunroof. Remember this is my first full pass ever on a tire, this pass would of been deep in the 10's with a 1.65 60', and that is not at full boost either.

[oneslowxa]

great times and great 60' for this time of year

[TurboGSR96]

Thanks man, to be totally honest I could of dropped the 60' alot, I have a beat front suspension setup, no traction bars, bad alignment and I had too much air in the slicks, not to mention I have never launched my car......haha

[oneslowxa]

what did you launch at

[TurboGSR96]

7500rpm not on the 2-step, I was almost positive I was going to break an axle instantly, otherwise I probably would launch lower and in boost. I had to replace my turbo so all the money I had for axles unfortunately went to that.

[oneslowxa]

what kind of axles are you running now?

[TurboGSR96]

Pep Boys $150 replacements, and most of the grease in them are now on the inside of my slicks, maybe that is what I slipped in on the first pass. The axles I want cost $1600, the ones I am going to get cost $1050, not a small investment.......

[frosti108]

wow its like you werent going anywhere, and then all of a sudden vtec lightspeed ahead

awesome congrats

[TurboGSR96]

Thanks, I cant wait to get back out there in the spring, now that I have the ice broken I know my next full pass will be a deep 10sec pass. My manifold has poor wastegate placement so that is going under surgery as I type this to fix that, because boost creep is a bitch. Once I get that fixed I can start to use the boost by gear to maximize traction in every gear. I looked at my datalog and I was spinning all of 1st, 2nd and the last half of 3rd gear, as I shifted a little to early into 3rd gear, my goal is to get up to 108-110 in the 1/8th and to a consistend 1.65ish 60', that will be a solid 10.50 pass if I can hit those lower numbers, in full street trim (fuel/boost) in a Honduh

[TurboGSR96]

Originally Posted by SvicksTc

wow man crazy numbers for such cold weather and hella of a fast integra...You street that beast....Please more on the mods and specs.....

Drove it all summer long every day, its completely streetable, full interior minus the rear seats.

Engine setup is nothing crazy, the Ethanol is what makes it all possible

Sleeved 1.8L 8.7:1 Comp (Piston/Rod)

Head was cleaned up, all Ferrea Valvetrain (i'm rev happy)
OEM GSR Cams
OEM Ignition
Edelbrock Int Man/ 70mm TB
Ball Bearing T67ho
3" DP and 3" Thermal Ex
Precision 750whp Intercooler/ 3" Charge Pipes
Twin Walbro 255hp's and 1000cc Injectors
B16 1-4th Gear / GSR 5th with a Quaife and Carbon Syncro's

[peteyturbo]

What kind of afr's are you aiming for under boost with E70?? (gasoline display)

[TurboGSR96]

It all displays the same, the sensor is looking for Lambda whether stoch is 14.7 or 10.0, so I tune for the same AFR as if it was Gasoline..... 11.7 - 12.0 is good for me, I ran out of Injector in the last 150' and saw 13.0 but everything is fine, I barely heard a ping going through the traps. I never saw 18psi going down the track until about 8k in 4th gear, then it crept fast to 22psi by 8500 when I went through the traps, definately was not expecting that....lol I thought it was pulling extra hard....haha

[SovXietday]

Good pass for this kind of weather! 24.5s MTs? I hope to be trapping near that next year.

I know what you mean about about the sliding all over the place feeling. My car did that on my first pass this year through 3rd at Maple, it was really strange getting tailwag in a FWD Civic lol.

[boostedfury]

wow awesome time and trap man..cant wait to see some 10s in the spring

[SvicksTc]

Cant wait to see this thing haul in the spring time....