STi V2 engine - TriStateTuners.com :: Home of Tristate Auto Enthusiast

peteyturbo · 11-08-2006, 07:14 PM

Figured someone may want this..It is a few months old but may still be avail..
http://www.specialstage.com/classifi...duct=86&cat=18

teh DIRT · 11-08-2006, 08:24 PM

good find! someone pick this up asap. i would if i had the cash!

This motor is sick! i know for a fact that it has piston squirters and a fully closed deck. Piston squirters allow piston temps to drop as low as 250*. that temp drop can give your pistons up to 50% more strength.

you can have this wired in for unde 1k probably.

so say 2k= 260hp stock.

2slowMX5 · 11-08-2006, 11:11 PM

nice.

Renegade_ · 11-08-2006, 11:22 PM

um, holy **** that is basically exactly what I am looking for - now I gotta make sure they give you wiring, ecu, etc - how can I get in touch with em and where are they located?

*edit* All over that ****, PM sent. Gotta find out where the motor is though.

jkjersey · 11-08-2006, 11:35 PM

Just keep in mind that when you do engine swaps it looks cheaper in the beginning than when you are knees deep in it. I just got the invoice on for my conversion and it was a couple thousand more than I anticipated. All of the upgrades or modifications that they performed to my GC8 were valid too.

The posting says August 2006. I doubt this engine is still for sale. If the compression on the engine was on point though it was a good deal.
----------------------------------------------------------------

Impreza GC8 JDM STI VI conversion
05 MCS

Drop by my page @ http://www.myspace.com/jkjersey

Renegade_ · 11-08-2006, 11:41 PM

Quote:

Originally Posted by jkjersey

Just keep in mind that when you do engine swaps it looks cheaper in the beginning than when you are knees deep in it. I just got the invoice on for my conversion and it was a couple thousand more than I anticipated. All of the upgrades or modifications that they performed to my GC8 were valid too.

I would be swapping the motor, not someone else. I dont care how long it takes, if I have both diagrams it will get done. I have the USDM pinouts but I can't write an all out chart yet because it has not yet been confirmed as to what motor I would buy and version matters on some of the pinouts. (albeit it would be an older v2/3 motor, preferably EJ20G closed deck)

*edit* And why the hell did you paste all that stuff in your post - its annoying as hell

peteyturbo · 11-10-2006, 02:27 AM

cool, I hope one of you guys end up with it..

11-08-2006, 07:14 PM	#1
peteyturbo Tri-State Post Whore Join Date: Feb 2006 Location: NE Phila. Member #1450 iTrader: (0)	STi V2 engine Figured someone may want this..It is a few months old but may still be avail.. http://www.specialstage.com/classifi...duct=86&cat=18

11-08-2006, 11:22 PM	#4
Renegade_ Tri-State Post Whore Join Date: May 2006 Location: NNJ/NYC Member #1912 My Ride: 1J Swaggon iTrader: (2)	um, holy **** that is basically exactly what I am looking for - now I gotta make sure they give you wiring, ecu, etc - how can I get in touch with em and where are they located? edit All over that ***, PM sent. Gotta find out where the motor is though. __________________ To view links or images in signatures your post count must be 10 or greater. You currently have 0 signatures.* Last edited by Renegade_; 11-08-2006 at 11:30 PM.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Want to Borrow: Engine Leveller (to be used with an engine hoist)	TROLL	Networking: requests and offers	2	10-18-2008 11:02 AM

11-08-2006, 11:11 PM	#3
2slowMX5 Tri-State Addict Join Date: Jan 2006 Member #1351 iTrader: (1)	nice.

11-08-2006, 11:35 PM	#5
jkjersey Tri-State Training Wheels Join Date: Dec 2005 Location: South Jersey Member #1148 iTrader: (0)	Just keep in mind that when you do engine swaps it looks cheaper in the beginning than when you are knees deep in it. I just got the invoice on for my conversion and it was a couple thousand more than I anticipated. All of the upgrades or modifications that they performed to my GC8 were valid too. The posting says August 2006. I doubt this engine is still for sale. If the compression on the engine was on point though it was a good deal. ---------------------------------------------------------------- Impreza GC8 JDM STI VI conversion 05 MCS Drop by my page @ http://www.myspace.com/jkjersey

11-10-2006, 02:27 AM	#7
peteyturbo Tri-State Post Whore Join Date: Feb 2006 Location: NE Phila. Member #1450 iTrader: (0)	cool, I hope one of you guys end up with it..