who in here knows there electronices

[antlip]

hey i have a dvd player head unit installed, 6x9s, 6.5s? i think they are, a mojo amp and 2 audio bahn subs.

well i was told my stock amp wasnt hooked up anymore.

i do have a 4 channel amp i want to put in its place. is this possible? i have all the wires from when the 2 amps were in my other car.

i also just bought tweeters and crossovers.

who in here knows how to hook up the highs amp and crossovers with my system i have in there now?

[TROLL]

did you sit there and think "hmm, the word electronics is in the title, i'm pretty sure this belongs in off topic"?
i'm going to move this to the electrical forum for you, please take care to place your thread in the appropriate section next time.
bryan

[ToTheIX's]

are you usin the rca wires for source or the actual speaker wires ?......either way run your source wires from the headunit to the amp and then out of the amp to the crossovers and from the crossovers to the speakers......make sense ?

[wgknestrick]

alachua, Cliff. Mofo knew every model # of electronics I had when setting up my Harmony remote and didn't even look at them or sell them to me.

[antlip]

first i want to appologize to troll, i over looked the electrical section. if i would of seen it i would of used it and not off topic.


yes i do understand what you mean. i pretty much had that part in mind. i just have to figure out the ton of wires now

[highmilehatch]

Originally Posted by antlip

hey i have a dvd player head unit installed, 6x9s, 6.5s? i think they are, a mojo amp and 2 audio bahn subs.

well i was told my stock amp wasnt hooked up anymore.

i do have a 4 channel amp i want to put in its place. is this possible? i have all the wires from when the 2 amps were in my other car.

i also just bought tweeters and crossovers.

who in here knows how to hook up the highs amp and crossovers with my system i have in there now?

If you only have one amp, your kind of screwed until you purchase another one. Here are your options. Run the RCA's from the headunit or DVD player to the amplifier. Now, you only have four channels. You can run two channels to your front speakers, let the headunit power the rear speakers, and bridge the other two channels to one single sub. Or, you can run all four speakers off your four channel amp and not have a sub. As for the crossovers, mount them somewhere, run the + and - wires that you'll be using for for the front speakers from the amp to each crossover. The crossovers will now split the highs and the lows. Run the correct + and - wires from the crossovers to the mids and tweeters. If you purchase a single two channel mono amp for your subwoofers, you can run all your speakers off of the four channel amp and the two subs off of the mono amp.