 |
|
05-21-2011, 02:14 PM
|
#1 |
|
Tri-State Aficionado
Join Date: Mar 2011
Location: Philadelphia, PA
Member #20166
My Ride: 2011 Chevy Camaro, 2001 Ford Focus ZX3 Rally Car iTrader: (0)
   |
Sparco Seat Brackets
I just bought a rally car to compete in 2 weeks. This guy was tall and the seats are way to back, I looked at it and they are held on the sparco brackets. The holes on the bottom determine if you slide the seat front or back. The seat is as front as it can be but still to far for me. Is there anyone in Philly or surrounding that can help me fix this. I think we need to unweld the brackets move it about 2 inches forward and then weld it gain to fix it.  If anyone thinks they can help me please let me know, and how much it would cost. I dont think this is to hard of a job. Thanks
__________________
To view links or images in signatures your post count must be 10 or greater. You currently have 0 signatures. To view links or images in signatures your post count must be 10 or greater. You currently have 0 signatures. To view links or images in signatures your post count must be 10 or greater. You currently have 0 signatures. |
|
|
|
05-21-2011, 02:43 PM
|
#2 |
|
Tri-State Addict
|
Why don't you get sliders?
__________________
Older Setup - Custom Tuned Stage 3 S4 Old Setup - Built 2.7 Single S366 Turbo New Setup - RS6's, Meth, Dumps. Sitting on Jack Stands To view links or images in signatures your post count must be 10 or greater. You currently have 0 signatures. |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
