|
|
#1 |
|
Tri-State Addict
|
Dump tube made by FSM
![]()
|
|
|
|
|
#2 | |
|
TST Ruined My Life!
|
Damn, they did a real sick job.
__________________
666 will never be the same, RIP big dawg! I'm gonna miss you Sherwood. Quote:
|
|
|
|
|
|
#3 |
|
Tri-State Aficionado
Join Date: Aug 2006
Location: The Hatfield, PA
Member #2384
My Ride: XXXX HP to the tires :P iTrader: (1)
|
Dan on the comeup !!!
__________________
To view links or images in signatures your post count must be 10 or greater. You currently have 0 signatures. - To view links or images in signatures your post count must be 10 or greater. You currently have 0 signatures. To view links or images in signatures your post count must be 10 or greater. You currently have 0 signatures. To view links or images in signatures your post count must be 10 or greater. You currently have 0 signatures. |
|
|
|
|
#4 |
|
Tri-State Aficionado
Join Date: May 2006
Location: Pa/De
Member #1983
My Ride: Big turbo civic. Biggish turbo Lexus....both will put a hurtin' on you ;) iTrader: (0)
|
Thanks for the props! It was nice meeting you as well. Hope that fan problem was cleared up and there was no problems on the ride home. Good luck with the ongoing project, looks like everything is going in the right direction with your setup and I liked what I saw!!!
Dan
__________________
72mm turbo 93'Civic Si EG hatch. Built motor, all the goodies (except the trans), 1000+hp potential, etc. etc. etc. 67mm turbo 96' Lexus GS300. 6spd V160 swapped, TRD LSD, etc. etc. etc. *Sold* 67mm bb turbo 03' Lexus IS300. Built motor, 272's, R154 5spd, twin disk, meth, Vertex kit, aggressive stance, etc. etc. etc. |
|
|
|
|
#5 |
|
Tri-State Addict
|
I have the fan installed it wasn't to bad only had to make a few cuts at the bottom to get around the lower rad hose. It pull a lot more air and draws more current to I blew the 20amp fuse after 5 minutes of running the fan. So I'm just going to rewire the fan and have it so I can turn it on and off with a switch and put a 30amp fuse in line. Thanks foR the compliments on the car. I still need to clean up a few things. Ho problems on the way home the water temp only when to 216 so much better then the 235 I had on the way to the shop.
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need a Tial dump tube made | Silverfc88 | [TST] Vendors | 2 | 11-19-2007 12:00 AM |
| dump tube for tial 38mm | koho2731 | (Past Vendors) | 5 | 05-13-2006 04:43 PM |