TriStateTuners.com :: Home of Tristate Auto Enthusiast - View Single Post

CleanNeon98 · 11-25-2007, 05:01 PM

Parts that need to be installed

Race header
test pipe
mid pipe
rear section

rear section needs to be cut and have a new muffler welded on
front motor mount has to come out for install of header (last I checked)
defouler needs to be made-i dont want a check engine light
one o2 sensor wire may need to be extended to fit the bung (there are 3 bungs and a plug in one of them, if it can be moved, the wire may not need to be extended). one bung in the test pipe 2 in the header, the lower one in the header is closed right now.

all hangers should line up, new ones will need to go on for the new muffler

PM me

11-25-2007, 05:01 PM	#1
CleanNeon98 TST Ruined My Life! Join Date: Jun 2006 Location: Philadelphia Member #2029 My Ride: "Honey Badger" Turbo Miata iTrader: (8)	exhaust install + weld Parts that need to be installed Race header test pipe mid pipe rear section rear section needs to be cut and have a new muffler welded on front motor mount has to come out for install of header (last I checked) defouler needs to be made-i dont want a check engine light one o2 sensor wire may need to be extended to fit the bung (there are 3 bungs and a plug in one of them, if it can be moved, the wire may not need to be extended). one bung in the test pipe 2 in the header, the lower one in the header is closed right now. all hangers should line up, new ones will need to go on for the new muffler PM me __________________ 2004 MAZDASPEED MX-5 : 328whp / 308wtq / 2500lbs 2012 Toyota Prius 2 : Daily Driver Last edited by CleanNeon98; 12-05-2007 at 07:20 PM.