I knew there had to be some "bad" rust somewhere on this car...
I noticed a little flake on the bottom of the car, picked at it, then stabbed it with a screw driver a few times... Then inside, the carpet was moist (have a leak in the hatch or door / window somewhere.
End results
Where I'm cutting it out
Started cutting it but stopped for the night (been up since 5:30)
A little on the drivers side in the same area:
Need to remove 1 more engine mount, AC compressor, and power steering pump...
Pulled the Trans from under the car...
What I did last weekend...
Framed opening, cut hole in wall, ran 220, and installed the 15,000 btu AC
