alright picked up some metal at tractor supply and some bolts, then cut up some metal and made some ****ty plates for the sides of the motor, tomorrow ill do the plates in the stock K member and bolt them in with a nice tractor supply bolt, hover the motor in there and then cut the tubing to the height i need. and weld away, weld weld weld. then i can pull the motor back out and finish weld/gusset whatever i need to and then drop it back in, and concentrate on the trans mount when i get my subframes in, say... wednesday i think?
then i can start on little **** like, is the truck intake gunna fit where should the turbo go, etc.
i also have yet to drill out one last header bolt snapped off
here is a pic of the fuel rail spacers i picked up at work we were throwing them out and they are exactly right to put the taller 80s in the truck intake, so now i have two sets.
i also drilled out my flexplate for the converter since its th350 bolt pattern, and installed the oil pan for tomorrow
here is a super ****ty engine mount plate
