[RyanG]

check this out. Im super stoked about this.. you road course junkies are gonna HEART this feature of our dyno ;)

"You can use DYNO-MAX “Pro” to create dyno simulations from on-vehicle data recordings. This information can be obtained from your DYNOmite Data Computer or many third-party engine management and data-acquisition system’s test files.
DYNO-MAX's "Simulate Road Load" is a special load control formula. Instead of adjusting the absorber to hold a fixed velocity, it continuously calculates the total Hp delivered against the theoretical vehicle drag (using both wind drag and road friction data) to determine how fast the vehicle should be going. It constantly readjusts the dynamometer load to hold that calculated road speed (even simulating vehicle inertia). Drag is calculated based on user entered Run Information parameters like Coast Down G’s and Vehicle Weight.
In fact, if your drag data is accurate, the dyno will hold the top speed to what the vehicle would actually attain on a level test track. With a fast acting absorber and controller, the acceleration (and required throttle feel) is similar to that of actually driving the vehicle on the highway."


so basically this means if you use some form of on track "digital nanny" that records your track runs with gps, g sensors, load sensors etc etc etc.. we can upload that information into our dyno software and it will "build" a track into its load control. So you can now fine tune your car just like being at the track! Wanna know what your motor is doing at a certain rpm at a certain speed during a certain time of the lap? Now you can ;) Not only that but for you hardcore drag racers, if you use some of the same software when you run your 1/4's we can also simulate that into the dyno cell. So yes you can actually do a 99% realistic 1/4 mile dyno pull !!!!

No expense was spared with this puppy.