[On Sale]

Ok, so i resurfaced my rotors in school, and put new brake pads on. Well i started to drive, and the pads were grinding the hell out of the rotors. so when i got home, i looked at it and my rotor was trashed. so i went and bought new rotors, another new set of pads, and a caliper from the junkyard.

So i installed everything, and the outboard pad is still getting stuck on the rotor, but not the whole pad, only a small section , the same thing happened the first time. I was considering sanding down the pads a little bit, but i dont think that will help.

Any suggestions on what to do?