[Vr-4-Life]

Hello,

I just swapped my motor and I need a tune. Here is my current setup

JDM D16A V-Tec 1.6
T3 57 Trim turbo
DSM 450CC injectors
Walboro 255
Crome chipped P08

other bolt ons...

The car had JDM D15B and the old tune is ok to drive it there.. It should give you something to start with... it ran pretty rich with the old motor in there.

I had the car tuned for 10PSI on the d15b but I'm not sure if its safe to run that on the d16a. my compression was about 190 in all 4.


Can you PM me with a cost and time estimate? I'd likely have to bring the car up on a Saturday or Sunday...