Quote:
Originally Posted by Vr-4-Life
well I'm back from engine depot with a d15b...
The motor seemed very clean... No oil stains around gaskets and seals.. no leaks that I could find anywhere.. it was a little oxidized like it was under a tarp outside or something, but over all it looks good.
I'm going to clean it up as much as I can today and pull the useless **** off it.
I need to go to harbor freight and get a good heater for my garage along with 12 point ratchet set and a 32mm socket...
Anyone know about the clutch alignment tools for these?
I'm just swapping the trans with the clutch still on it.. I've never done it before.
|
the clutch is on the motor. well in between the flywheel and presure plate. ur gonna have to take all 3 and put them onto ur new motor. and i have an alignment tool if u need one, witch u will. pm me