TriStateTuners.com :: Home of Tristate Auto Enthusiast - View Single Post - 7th gen accord coupe on 352 near rt1 10/20

07-6speed-Navi · 10-31-2009, 10:18 AM

End to end on the TB. Inside is minimal. The intake runners absolutely sucked putting in. Theres 2 bolts on the pass side on the end of the runners that are very difficult to get access to. Expect to cut your hands and drop bolts in the valley of the motor. The manifold is for a 2007 accord I ordered brand new from Honda and never installed it after the work. When you do the cams expect to have an oily mess and residue burning off for at least a couple days. I had red exhaust for a week from the lube used. Unfortunatley unless the cars tuned just putting in the cams the car doesnt start to pull hard till late rpms.

Yes I have the Outlaw spacers running a J30 accord manifold

10-31-2009, 10:18 AM	#17
07-6speed-Navi Tri-State Training Wheels Join Date: May 2009 Location: Delco Member #13729 My Ride: 07 AV6 iTrader: (0)	End to end on the TB. Inside is minimal. The intake runners absolutely sucked putting in. Theres 2 bolts on the pass side on the end of the runners that are very difficult to get access to. Expect to cut your hands and drop bolts in the valley of the motor. The manifold is for a 2007 accord I ordered brand new from Honda and never installed it after the work. When you do the cams expect to have an oily mess and residue burning off for at least a couple days. I had red exhaust for a week from the lube used. Unfortunatley unless the cars tuned just putting in the cams the car doesnt start to pull hard till late rpms. Yes I have the Outlaw spacers running a J30 accord manifold __________________ If your going to do it then do it right......... Last edited by 07-6speed-Navi; 10-31-2009 at 10:34 AM.