[russiankid]

You are going to end up spending roughly $500 on parts. You'll need a clutch, pilot bearing, throw out bearing, new slave cylinder, shifter bushings, rear output shaft seal and front input shaft seal(not sure if you can replace it, may not need it). You can also replace the center support bearing on the driveshaft. If you're going to get in there to do the clutch, do it right.

Oh and do the rear main seal on the engine. You do not have to remove the starter to get the trans off. You will need to loosen it though. Its a bitch and a half to get the starter out on the M50, S50, S52, or M52.