TriStateTuners.com :: Home of Tristate Auto Enthusiast - View Single Post

yellow2000S/R · 03-12-2009, 03:37 PM

Go to harbor freight and get this for $120: http://www.harborfreight.com/cpi/cta...emnumber=98357

I have one and it works fine... You may want to invest in a better slide hammer tho, the one that comes with it sucks and slips off after 2-3 pulls. Just grind down to bare steel whee you put the studs, start in the lowest point, and dont overpull. If the panels get a "can" effect where it easily pops in/out just heat it up and cool with a damp rag.

Wish I had pics of the door before... it was creased on the curve along with under the molding was caved in around 1/2". Pulled, light coat of filler. 1st pic there is a light coat on the bottom not blocked yet.

03-12-2009, 03:37 PM	#7
yellow2000S/R Tri-State Post Whore Join Date: Sep 2006 Location: York, Pa Member #2462 My Ride: 66 Fairlane, 73 F250, 79 F150, 82 GL500, 96 F250, 98 Wrangler, 04 Hoe, 06 Wrangler, 11 Silverado iTrader: (2)	Go to harbor freight and get this for $120: http://www.harborfreight.com/cpi/cta...emnumber=98357 I have one and it works fine... You may want to invest in a better slide hammer tho, the one that comes with it sucks and slips off after 2-3 pulls. Just grind down to bare steel whee you put the studs, start in the lowest point, and dont overpull. If the panels get a "can" effect where it easily pops in/out just heat it up and cool with a damp rag. Wish I had pics of the door before... it was creased on the curve along with under the molding was caved in around 1/2". Pulled, light coat of filler. 1st pic there is a light coat on the bottom not blocked yet. Last edited by yellow2000S/R; 03-12-2009 at 03:43 PM.