Well I was told I should create a build thread for my car, so here goes hope you like it.
exterior when I first got it.
gauge cluster(stock)
stock spring, and tein s-tech
spring installed
ram air intake
full cold air
header 4 to 1
painted valve cover
powder coated candy apple red
what my engine bay currently looks like
trans removal
fidenza 7.5 lbs flywheel and exedy clutch
shifter removal
B&M FTW
Wheels after I painted them, will be getting powder coated at a later date
front motor mount and the awr 95 durameter mount
stock rear mount and new awr mount
more spring crap
rear motor mount installation( it was a bitch)
more rear strut install
the new go fast part to be installed soon!
ractive tip, with dynomax chambered muffler
some random pics
new turbo manifold, I have it but these are the online pics.
I don't have pics of everything I did and I am sorry for that.
But the mods as of now are,
full cold air intake
4-1 header
custom built(by me) 2.5" exhaust with dynomax muffler, new cat and ractive tip
jdm mazdaspeed 241 deg cams
awr front and rear 95 durameter motor mounts
awr adjustable sway bar endlinks
tein s-tech springs
torsen limited slip diff
fidenza flywheel
exedy clutch
B&M short shifter
some stereo stuff, head unit subs and amp(but that **** doesn't matter
I am soon to be installing a td04 turbo set to 7psi
front mount intercooler
cast top mount manifold
innovate wide band sensor and gauge
rising rate fuel pressure reg
and all the other small stuff
no timing or ecu mods just yet
after the turbo is done i am looking into integral cams
exterior mods are, blakc 16" stock wheels
all black badges( where chrome)
Red painted front calipers, will soon have all four powder coated the same color as my valve cover, IC piping will be that same color.
Will update this when I get new stuff, I have to take some more pics as I do have parts in my bed room for the turbo kit.