The 67mm on the left has a 4" inlet and a 3" outlet on the compressor side
. Turbine housing is a .82 A/R T4 with a 3" v-band outlet...
The 61mm on the right has a 3" inlet and a 2" outlet on the compressor side. Turbine housing is a .70 A/R T4 divided with a 3" v-band outlet.
Intake pipe is prebent mandrel at XPSI... I know I'll be looking for a 4" with a 45 degree bend, not sure what you'll need.
And I'll ask about the filter... I've been talking to him a lot about his paint work since it came out so good. Wish I could just have him come up and bang this out! My life this week is pretty much all sanding. It sucks but I'll do what it takes to make this happen without compromise...