TriStateTuners.com :: Home of Tristate Auto Enthusiast

TriStateTuners.com :: Home of Tristate Auto Enthusiast (http://www.tristatetuners.com/forum/index.php)
-   Audi / Volkswagen Talk (http://www.tristatetuners.com/forum/forumdisplay.php?f=64)
-   -   abs light after front bearings install (http://www.tristatetuners.com/forum/showthread.php?t=97011)

STiGuy06 04-07-2010 09:21 PM

abs light after front bearings install
 
the ABS light came on then went off and the Brake light on the dash flickers and make a noise....any ideas? I did notice the sensor cover has a small gash in it, so i'll put electrical tape over that...but any other ideas if its not that.

TROLL 04-08-2010 01:38 AM

wheel speed sensor... is that the sensor you're talking about? any time you're working with wheels, brakes, hubs, or in that area... there's a chance of damaging the wheel speed sensor and it can cause this. pretty common, just answered the same question for someone on supraforums yesterday.

STiGuy06 04-08-2010 03:39 PM

Brake pad low width sensor. It says that in the write up "How-To" on Vortex... I took it to my mechanic because i've had enough haha...I miss driving it because i can't drive my STi daily, too much monies for gas.

vDevilu 04-08-2010 04:07 PM

sounds like the wear sensors on pads. I did that changing out my springs.... There is a way to turn it off with Vag-com.


All times are GMT -4. The time now is 10:42 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.