Exhaust shops nearby the Levittown area
 

Anyone know of any?

Take Low Cost Exhaust off the list, cause they don't want to swap my cat out. (something about it being under warranty for 8yrs/80k miles or some BS. I should just shove a metal rod in it and say I ran over something.)

Just looking to get a 1.73" cat swapped out with a 2.25" cat (already have) and have the flanges fabbed up and everything welded. Will probably use them for a future 3" turbo back weld job.

Go to Competiton Exhuast down on Rt 13. They do good work there.

Think they'll actually do it for me? And maybe do a header grind/patch for this stupid AIR plumbing? They do stainless, right? :p

All I know is, I got a backfire the other night (like 3 nights ago) and my car's been blowing some mad smelly smoke out my tailpipe. I know for a fact my cat was in bad condition, so maybe it finally took a powder. Be nice to get everything done.

Clint if you don't have any luck, I'm sure the dealership would put your cat on for you. Unfortunatly, u'll be paying a lot...

That's why we call it the Stealership, Alex.

Try Competition exhuast on Rt13. They made a test pipe for one of my friends.

Other than low cost..I don't really know any places :)

Yeah go to Competition Exhuast Clint they put my exhuast on they did a good job. You are going to pay alittle more.

**** that ****... competition probaly wont touch your car unless your putting flowmasters on it...they pulled that with our mustang..the owner gary who used to run with low cost wont touch a newer car with cats.

Take it to NE Exhaust off old 13..Gary nueser or something its right in the first complex when you turn onto old 13 he has the last garage to the right.

The Best Shop Period....

LOW COST EXHAUST (right by Oxford Valley Mall)

You don't read much, do you?

Mufflex over in jerseys good

talk to JasterM5..he is pretty good from what i have seen and heard...if you tell him exactly what you need he could hook you up

Not really. But they were happy to lop off my muffler for $60.

Yes, technically, removing the catalytic converter is a federal offfense.

Magnaflow does provide the forms inside their boxes to remove it, I believe.

All Star muffler shop in Morrisville near bridge st. is good...they do all the custom bends, etc...good guys

I should mention:

At the moment, piping isn't what I'm looking into doing. I'm looking at a cat swap, so if any of these shops still apply, let me know tonight, or if I'm at the meet on Thursday, there too.