TriStateTuners.com :: Home of Tristate Auto Enthusiast

TriStateTuners.com :: Home of Tristate Auto Enthusiast (http://www.tristatetuners.com/forum/index.php)
-   Member Journals (http://www.tristatetuners.com/forum/forumdisplay.php?f=113)
-   -   Project 10 Sec. Daily Driven RSX- Twin Scroll, Full Race.*Update* 8/19 Dyno Graphs!!! (http://www.tristatetuners.com/forum/showthread.php?t=30373)

NJslvrtypes 03-18-2007 10:07 PM

Project 10 Sec. Daily Driven RSX- Twin Scroll, Full Race.*Update* 8/19 Dyno Graphs!!!
 
After purchasing my 02 RSX Type S w/ 20K in 2003, I immediately starting modding. I originally planned the basic NA route. Adding the usual cold air intake, RH, and Greddy Evo2 exhaust. I was not impressed. Soon I began thinking bigger numbers and purchased IPS K2 cams, Eibach valvespring and retainers, along w/ Hondata K-Pro. That was shortlived after viewing timeslips online of similar setups and the hp per dollar cost. It was apparant that this small 2.0L needed some forced induction.
I ditched the cams and ordered the first "sidewinder" manifold and kit available at the time, SCI motorsports. Full-Race's kit was not available at that time nor was there even a solid ETA. I wish I had waited. The kit was ordered in 05 and was not received until 13 months later!!! In that time I researched heavily motor blueprinting and balancing and decided I would give it a shot.
I purchased a overreved K20 with a like new block for 450 bucks, send it to Golden Eagle to be sleeved, and the rest of the parts chosen are listed later. After building the block, I pulled my stock motor, tore it down, tore the head down, cleaned everything, installed valve spring/retainers/new seals and switched to the built block. I also installed a Clutchmasters twin disc clutch, followed by my crazy fuel setup, and then finally the SCI turbo kit. Here is a list most of the parts:

Motor:

Golden Eagle Sleeves
Block Bored .040 over
Carrillo Rods
Wiseco 9:1 Pistons 87MM
Supertech Valvetrain
Cosmetic Headgasket/ARP Headstuds
OEM Main/Rod Bearings

Fuel Setup:

Bosch 044 Fuel Pump
Precision 1000CC Fuel Injectors
-8AN Feed/-6AN Return
BDL Fuel Rail
Aeromotive A1000-6 FPR
Marshall Fuel Pressure Gauge
Stainless Steel Braided Lines/Earl Filter/Earl AN Fittings
Custom Fuel Pickup

Exterior:

Aftermarket OEM Sides/Rear
Greddy Front Lip
JDM Replica Headlights
Ace Manta 18's on Kumho ASX Rear/BFG KDW T/A Front
20% Tinted Windows

Turbo Setup:

SCI Turbo Kit
T3/T67 Stage 3 Compressor .63A/R <--- to small
2.5" DP <-----huge restriction
Kteller 3" Exhaust w/ Magnaflow Muffler
Apexi AVCR Boost Controller
Hump Couplers/T Bolt Clamps

Miscellaneous:

K-Pro ---> Tuned By Jeff Evans
Tein Basic Full Coilovers/Ingalls F+R Camber Kit
Autometer Boost, EGT, and Oil Pressure Gauges
Alpine IVA-D300 In Dash Monitor/DVD Player
Compustar Alarm
Candy Blue Powdercoated Valvecover
Weapon R Catchcan
Full Size Battery Relocated To Trunk
Spoon Sports DC2 Car Cover (Yes it fits pretty well)

NJslvrtypes 03-18-2007 10:15 PM

Built motor finished:

http://i52.photobucket.com/albums/g3...s/P4290008.jpg

During the teardown:

http://i52.photobucket.com/albums/g3...s/P7250003.jpg

Fuel Setup:

http://i52.photobucket.com/albums/g3...s/P6070005.jpg

Bosch Fuel Pump

http://i52.photobucket.com/albums/g3...s/P6070007.jpg

Clutchmasters Twin Disc

http://i52.photobucket.com/albums/g3...s/P5060017.jpg

Motor Out:

http://i52.photobucket.com/albums/g3...s/P5030008.jpg

NJslvrtypes 03-18-2007 10:15 PM

http://i52.photobucket.com/albums/g3...s/P5040009.jpg

All built and boosted, ready for tuning:

http://i52.photobucket.com/albums/g3...s/P8300024.jpg

On its way to Evans.. 0 Miles on motor!!!!

http://i52.photobucket.com/albums/g3...ilerResize.jpg

Evans Tuning Easton PA

http://i52.photobucket.com/albums/g3...s/P8310002.jpg

Old Dirty Engine Bay

http://i52.photobucket.com/albums/g3.../EngineBay.jpg

PaleDSM 03-18-2007 10:19 PM

Those front tires are going to be begging for mercy.

NJslvrtypes 03-18-2007 10:27 PM

Results from Tuning

Solid Line C16 28.5 PSI
Dotten Line Pump Gas 15 PSI

http://i52.photobucket.com/albums/g3...ilverrsx-1.jpg

NJslvrtypes 03-18-2007 10:33 PM

If you have a high hp K20 be ready for this....

http://i52.photobucket.com/albums/g3...nageResize.jpg
http://i52.photobucket.com/albums/g3...4thResize2.jpg
http://i52.photobucket.com/albums/g3...yOutResize.jpg
http://i52.photobucket.com/albums/g3...s/IMG_0344.jpg
http://i52.photobucket.com/albums/g3...s/IMG_0284.jpg

Had to purchase a 12 ton press to complete the job and for that matter every time it does happen

NJslvrtypes 03-18-2007 10:39 PM

Some toys in my garage where it all goes down..
New scissor lift
http://i52.photobucket.com/albums/g3...s/IMG_0409.jpg
http://i52.photobucket.com/albums/g3...s/IMG_0496.jpg

Team Dynamics Pro Race V2 15's w/ M+H 24.5/8.5 Slicks
http://i52.photobucket.com/albums/g3...s/P6070003.jpg

NJslvrtypes 03-18-2007 10:43 PM

After about 4K of driving the manifold cracked in three different places. Hence why I wish I waited a few months for Full Race to release their kit. Not too mention the company has gone under and is giving me the runaround on their lifetime warranty.

http://i52.photobucket.com/albums/g3...s/IMG_0272.jpg

Not only this but switching to a FR Mani/DP now would require ditching everything on my current setup but the intercooler.

NJslvrtypes 03-18-2007 10:48 PM

As it sits now I am owed over 4K by vendors that have not come through. They include:

Moto-C
FRE Racing
SCI Motorsports

Also somebody attempted to break in to the car the other day causing at least 700 in damage to the hood, support beam, etc. Thankfully due to a few tricks they did not suceed in getting anything at all :mrgreen:

This week I will be picking up my fuel pumps to start on the new fuel system. Also, a partial FR kit will be ordered from Evans Tuning this week. I look forward to my retune this coming spring which should make these numbers look pathetic.

I will update w/ progress on the new turbo, trans, and fuel setup as progress is made.

NJslvrtypes 03-18-2007 10:51 PM

Quote:

Originally Posted by PaleDSM (Post 485706)
Those front tires are going to be begging for mercy.

Boost by gear via AVCR, BFG Drag radials, Innovative motor mounts, semi stiff suspension and a little right foot control is definately needed. But with some driver skill it definately holds its own from stoplight to stoplight.

02rex 03-18-2007 10:54 PM

damn bro, looks sick...goodluck with everything. should be a real beast.

PaleDSM 03-18-2007 10:56 PM

Looks like you are seeing great results from the build. The 3rd set of pictures showed up after I had posted.

1988 Olds 03-18-2007 10:57 PM

Looks amazing man. Any Track Times

NJslvrtypes 03-18-2007 11:24 PM

Quote:

Originally Posted by 02rex (Post 485764)
damn bro, looks sick...goodluck with everything. should be a real beast.

Thanks I need a lot of luck considering everything I have dealt w/ in the past. I was tempted to part out since all this crap happened at once but now its a mission to finish her up.
Quote:

Originally Posted by PaleDSM (Post 485771)
Looks like you are seeing great results from the build. The 3rd set of pictures showed up after I had posted.

Yeah, it was running great for a few K. I was actually driving it daily and commuting to college in wayne every morning. It was a little scary being so close to Paterson with a pretty big FMIC though.

Quote:

Originally Posted by 1988 Olds (Post 485776)
Looks amazing man. Any Track Times

I had a fuel related issue on the way to Island dragway one night and learned a valuable lesson. Carry extra relays and an electrical tester in the glovebox. Shortly thereafter the manifold cracked beyond repair.

I'll get some track times right after tuning this spring. There is only one 10sec RSX in the US right now, my goal is to become the first on the East coast :wink: But baby steps first, the first few times to the track will be on pump gas/low boost. Then I'll ease into C16 tune.

arkadyzv 03-18-2007 11:36 PM

Car looks great, good luck with finishing it up.

TalonTsi97 03-19-2007 02:15 PM

Awesome build, i love everything about it. Good luck on the new setup, im happy to see you stayed with it and didnt part it out.
Have any videos from the dyno?

JSeoul 03-19-2007 02:27 PM

Very Nice. Definitely inspiring.

Evo8kid 03-19-2007 02:30 PM

dude, your car is sick.

Jordanz3 03-24-2007 12:10 AM

nice billy :)

NJslvrtypes 03-27-2007 06:45 PM

Quote:

Originally Posted by Evo8kid (Post 486367)
dude, your car is sick.

Quote:

Originally Posted by Jordanz3 (Post 492145)
nice billy :)

Thanks guys, lets see that Evo Ming:thumbup:


All times are GMT -4. The time now is 10:50 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.