Dump tube made by FSM
 

I finally got my dump tube made on friday it looks great nice welds and good location to dump. Both Dan and Josh were very helpfull and nice guys :thumbup: They also hooked me up with the fan problem I was developed on the way up to the shop.

http://img.photobucket.com/albums/v6...1/DSC01339.jpg

http://img.photobucket.com/albums/v6...1/DSC01334.jpg

Damn, they did a real sick job.

Dan on the comeup !!!

Thanks for the props! It was nice meeting you as well. Hope that fan problem was cleared up and there was no problems on the ride home. Good luck with the ongoing project, looks like everything is going in the right direction with your setup and I liked what I saw!!!

Dan

I have the fan installed it wasn't to bad only had to make a few cuts at the bottom to get around the lower rad hose. It pull a lot more air and draws more current to I blew the 20amp fuse after 5 minutes of running the fan. So I'm just going to rewire the fan and have it so I can turn it on and off with a switch and put a 30amp fuse in line. Thanks foR the compliments on the car. I still need to clean up a few things. Ho problems on the way home the water temp only when to 216 so much better then the 235 I had on the way to the shop.