any one have a series 2 AEM standalone for their ODB1 honda?
 

so my buddy and i are tuning a AEM standalone on his 95 integra and we have a couple glitches. the car drives fine but when u rev at idle the car cuts at 3k and the RPM's bounce between like 500 and 1000. this only happens at idle as well.

the O2 sensor also reads 9.95 all the time but i think this isent the factory sensor and is only used for widebands, is this true?

we also cant check the timing on the car because there are no marks left on the crank pulley. what do we do?

Is his car turboed?...if so go and get a REAL tune
Check all the wires theres a lot to go wrong...especially if hes splicing into his ecu harness
maybe there's a "launch control" setting set to the wrong setting

Honestly all the standalone crap is for readouts and conversation starters for anyone that gets into your car

take out the the problem and then you dont have one

good luck

sounds like a 2step is engaged.