TriStateTuners.com :: Home of Tristate Auto Enthusiast  

Go Back TriStateTuners.com :: Home of Tristate Auto Enthusiast > Tech > Drivetrain
Speed 1
Register Rules & Info Mark Forums Read

Notices

Reply
 
Thread Tools Display Modes
Old 09-08-2013, 12:26 PM   #1
1slowteg
Tri-State Training Wheels
 
1slowteg's Avatar
 
Join Date: Oct 2007
Location: PA
Member #6010

My Ride:
95 turbo integra, 89 turbo z31, 88 na z31 (RIP), 99 benz c230k, 84 porshce 944

iTrader: (0)
clutch pedal stuck to floor while driving, still in gear!

I have a 95 Integra. GSR Trans, ACT 6 puck, stock slave, stock master, stock lines.

I was going on a drive. Everything was normal. Pull out from a stop light. 1st gear, good. 2nd gear, good. 3rd gear, goes in, go to let the clutch out..clutch pedal stays stuck to floor BUT the vehicle is still in gear, not in neutral. So I limped it to the closest gas station. Pulled out on the pedal. And everything acted normal. Check fluid, lines, everything. All seemed fine.

What the hell caused this? any ideas? I'm stumped.
__________________
Quote:
"This guy thinks he's Captain Tyin' knots..."
1slowteg is offline   Reply With Quote
Old 09-08-2013, 01:40 PM   #2
yellow2000S/R
Tri-State Post Whore
 
yellow2000S/R's Avatar
 
Join Date: Sep 2006
Location: York, Pa
Member #2462

My Ride:
1996 7.3 f250, 2001 Focus wagon

iTrader: (2)
Any fluids at the slave cylinder? I had this happen after putting a new clutch into a different car. Drove fine for like 100 miles and then the slave started pushing the pin out too far and it was leaking/catching causing the pedal to stay down.
yellow2000S/R is offline   Reply With Quote
Old 09-08-2013, 08:53 PM   #3
1slowteg
Tri-State Training Wheels
 
1slowteg's Avatar
 
Join Date: Oct 2007
Location: PA
Member #6010

My Ride:
95 turbo integra, 89 turbo z31, 88 na z31 (RIP), 99 benz c230k, 84 porshce 944

iTrader: (0)
But if the slave pushed the pin out too far wouldn't it disengage the clutch? That means I wouldn't have been able to drive it like that. I was in 3rd gear driving fine.

I have good fluid level and have 1000+ miles on the clutch so far with no other problems. I just don't get it.
__________________
Quote:
"This guy thinks he's Captain Tyin' knots..."
1slowteg is offline   Reply With Quote
Old 09-09-2013, 02:15 PM   #4
Ds650rida
Tri-State Aficionado
 
Ds650rida's Avatar
 
Join Date: May 2007
Location: SJ
Member #4808

My Ride:
636/NA6/OBS

iTrader: (1)
Send a message via AIM to Ds650rida
Could have pushed past the fork. Most likely a leaky slave/master


Sent from my iPhone using Tapatalk - now Free
Ds650rida is offline   Reply With Quote
Old 09-16-2013, 07:59 PM   #5
jpalamar
TST Ruined My Life!
 
jpalamar's Avatar
 
Join Date: May 2009
Location: Collegeville, PA
Member #13773

My Ride:
03 Corvette Z06

iTrader: (3)
I would bleed the system really good before anything else.
jpalamar is offline   Reply With Quote
Old 09-17-2013, 01:06 AM   #6
1slowteg
Tri-State Training Wheels
 
1slowteg's Avatar
 
Join Date: Oct 2007
Location: PA
Member #6010

My Ride:
95 turbo integra, 89 turbo z31, 88 na z31 (RIP), 99 benz c230k, 84 porshce 944

iTrader: (0)
it appears to be a sticky slave cyl. it was time to change this stuff anyway. ordered new master, slave, and SS clutch line. should be good to go now

thanks for the suggestions
__________________
Quote:
"This guy thinks he's Captain Tyin' knots..."
1slowteg is offline   Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
Brake Pedal going to the floor - 2004 WRX Wagon BustedUjoint Subaru Talk 1 10-09-2009 12:07 AM
How to adjust the clutch in a miata from the pedal Cardriverx Mazda Talk 1 06-14-2007 11:27 PM
Clutch pedal problem RedTSIturbo96 Drivetrain 3 05-14-2006 01:34 AM


All times are GMT -4. The time now is 10:39 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.