08-08-2008, 03:25 PM | #1 |
Vendor
|
P&L Motorsports HighFLO intake
Additionally this elegant, 3" brushed aluminum intake is fully TIG welded to ensure the proper seal that is lacking from so many other intake designs. Utilizing a full 3" cross section, the intake is designed to offer MAF resolution up to 450HP on a Subaru non drive-by wire ECU (limited to 4.74 MAF volts), and up to 500HP on a Subaru drive-by wire ECU which goes up to a full 5 MAF volts. The intake design is actually swept back placing the filter in what we've found to be the "coolest" spot under the hood. Several other intakes were tested and this placement actually measured about 30F cooler under tuning conditions compared to a comparable high horsepower "Big MAF" sized intake. Finally, the short design is setup to use a small profile coupler to attach to a factory inlet hose, or slide directly into most aftermarket silicone hoses (I.E. Samco), allowing us to utilize a HUGE K&N air filter to make sure there are zero questions about pressure drop and airflow to even the largest of standard location turbo chargers. Current front mount testing shows zero compatibility issues with the following unit: TurboXS 1st generation and 2nd generation FMIC |
08-08-2008, 09:27 PM | #2 | |
The [TST] Don
Admin
Join Date: Dec 2004
Location: Langhorne, PA
Member #3
My Ride: 07 Bugeye STi - 94 Supra iTrader: (6)
|
sounds like a good design, and P&L is a really solid company. if you have any photos of it installed in an engine bay i'd be interested to see where it sits in the bay.
__________________
To view links or images in signatures your post count must be 10 or greater. You currently have 0 signatures. | To view links or images in signatures your post count must be 10 or greater. You currently have 0 signatures. Quote:
To view links or images in signatures your post count must be 10 or greater. You currently have 0 signatures. | To view links or images in signatures your post count must be 10 or greater. You currently have 0 signatures. |
|
08-25-2008, 03:37 PM | #4 |
Tri-State Post Whore
|
Do you have any IAT data for this intake since it sits under the hood instead of the fenderwell? Any plans for a big maf CAI from P&L to rival the APS 70mm? I love the MAF scaling, I really wish every intake vendor included that, it would help those of us with Street Tuner, etc. out TONS.
__________________
Member Journals: To view links or images in signatures your post count must be 10 or greater. You currently have 0 signatures. / To view links or images in signatures your post count must be 10 or greater. You currently have 0 signatures. / To view links or images in signatures your post count must be 10 or greater. You currently have 0 signatures. / To view links or images in signatures your post count must be 10 or greater. You currently have 0 signatures. / To view links or images in signatures your post count must be 10 or greater. You currently have 0 signatures. / To view links or images in signatures your post count must be 10 or greater. You currently have 0 signatures. |
08-25-2008, 04:17 PM | #5 | |
Vendor
|
Quote:
|
|
Bookmarks |
|
|