TriStateTuners.com :: Home of Tristate Auto Enthusiast  

Go Back TriStateTuners.com :: Home of Tristate Auto Enthusiast > Vendor Marketplace > [TST] Vendors > Extreme PSI
Mishimoto
Register Rules & Info Mark Forums Read

Notices

Reply
 
Thread Tools Display Modes
Old 07-17-2017, 05:57 PM   #1
extremepsi
Vendor
 
extremepsi's Avatar
 
Join Date: Feb 2006
Location: Bensalem, PA
Member #1500

 
iTrader: (0)
Cast Magnus Intake Manifolds in-stock at Extreme PSI

Cast Magnus Intake Manifolds in-stock at Extreme PSI




Click here to shop!

The Design & The Results

Cast in A356 Aluminum with a wall thickness of 3/16"; the Plenum shape features a varying contoured tapered profile at a volume of 5 liters. The runners themselves are completely revolutionary in their design; featuring an integrated velocity stack that gradually transitions into the head port profile. It was designed entirely against the shape of the original cylinder head port taking advantage the 10° port entry of the EVO head maintaining un-interrupted laminar flow. The Magnus Cast Intake Manifold will work with throttle bodies from stock right up to 100mm and have seen consistent gains from 30 awHp to 52 awHp with varying setups. Transient boost response is exceptional and it can bolt together in a stock location if required while still being able to be used on a full blown race application.

Features

2 years of research and development
Cast from A356-T6 Aluminum Alloy
High quality casting gives a superior surface finish
Enhanced flow dynamics utilizing CAD Modeling & CFD simulation
Flowbenched and dynamically tested
Dynotested proven up to 50 HP
Ability to flow 100 lb/min (1000 HP) of air at 60PSI while maintaining equal flow distribution
Can be installed in stock location with clearance for original battery (with adaptor)
Install kits are optional and can be purchased to include heat barrier gaskets, and adaptor plate to run stock throttle bodies (easily upgradeable). Remote map sensor boss is optional for use with factory ECU's
Stock turbo gains up to 40HP
15 degree entry to the throttle body facilitates intercooler plumbing
Can be configured for 8 injector setup.
Fits factory fuel rail or Magnus high flow fuel rails
5L plenum with contoured velocity stacks molded into the floor for huge top end and minimal turbulence
Magnus Quality and Lifetime warranty

Applications: EVO IV to IX

Finish: Cast aluminum finish
Color: Raw aluminum


Click here to shop!
__________________

To view links or images in signatures your post count must be 10 or greater. You currently have 0 signatures.

215-244-4295
extremepsi is offline   Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
New JMFab Race Intake Manifold IN STOCK at Extreme PSI extremepsi Extreme PSI 0 02-23-2017 09:59 PM
Need advice on intake manifolds ndubz Subaru Talk 64 01-07-2009 02:32 PM
Intake manifolds Jp2slow Subaru Talk 2 09-16-2007 11:18 PM


All times are GMT -4. The time now is 09:20 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.