finished that little HVAC vent gauge pod. i think it turned out alright for the amount of effort.
took apart the factory vent and 3d printed a new cover plate. I did my best to open up as much area as possible so that it would still be functional.
test fit of gauge.... perfect.
after some super glue, sanding, more glue, more sanding and a bit of paint....
and finally installed back into the dash.
i have yet to decide which gauge will fill this location. I have this A/F as well as the matching Boost gauge. The other gauge will go into a custom 3d printed steering column gauge similar to this one available from autometer
http://www.xtremediesel.com/images/p..._AutoMeter.jpg. But why pay $40 when you have solidworks and a 3d printer