thanks i'll check it out...
new pichers from sunday...
awwwwww
Tial 44mm, adapter flange, Greddy manifold ceramic coated by
www.boneheadperformance.com
test fit of genuine Boost Logic downpipe... this is what I will be using now, sending to Bonehead to have ceramic coated. Also notice (ugly) shiny silver DEI Heat Sheath on coolant line next to downpipe
another angle
DEI Heat Sheath to protect the coolant hose from excessive heat from the downpipe since they are less than 1/2" apart...
this is in the rear hatch, behind the rear seat (which is folded down in these photos). here is the series of how we will be laying things out... its just a rough fit to get an idea of where everything will be positioned
mdf wood floor cut to fit with hole for power wire and factory wheel speed sensor wires
modified east penn plastic battery tray
Deka ETX18L battery - 300 CCA (tested at 350). 8" x 6.5" x 3.25"
150A Circuit Breaker
Fuel pump relays
Representative area of fuse box
And here is with the rear seat up
