2002 Cavalier LS Sport - weapon of mass cone killing
bought the car new in 2002 and haven't stopped spending money since.
current mod list: Engine mods: ~GMPP m62 supercharger ~3.1 ZZP quick change pulley ~CX Racing heat exchanger ~Hptuners custom tune by Oldskool ~AEM cold air intake ~RKSport lower motor mount ~RKSport upper motor mount ~B&M short shifter ~Pacesetter 4-1 ceramic coated header ~custom bent 2.5" exhaust with Borla XR-1 muffler, Magnaflow resonator, Catco high flow cat, and 4" Magnaflow tip ~Custom Car Grills lightened crank pulley ~Prothane Urethane tranny mounts ~Red powdercoated cam cover Suspension mods: ~Tein SS Coilovers ~RKSport subframe brace ~Ractive front strut tower brace ~Freedom Design rear strut tower brace ~Addco 25.4mm front sway bar ~Addco 25.4mm rear sway bar ~RKSport polyurethane A-arm bushings ~Satch's delrin torsion beam bushings ~Misnblu custom trunk brace ~17x8 5zigen FN01RC wheels ~245/40/17 Hankook k110 v12 evo's ~Baer 13" big brake kit front ~Baer 12" big brake kit rear Exterior mods: ~G3 autosport oem carbon fiber hood ~VIS carbon fiber trunk lid ~Wings West W-type front valence ~03 rear bumper with GM Xtreme tuner rear valence ~carbon fiber fuel door ~custom painted headlights ~black corners ~96-99 toyo tails ~shaved side moldings ~fully retracting rear windows ~15% window tint Interior mods: ~Tenzo R rally seats ~Tenzo R version 5 steering wheel with momo hub adapter ~Weapon-R 4 point harnesses ~Lotek Triple Gauge Pillar ~AEM Wideband o2 gauge ~Autometer Carbon Fiber series boost gauge ~Autometer Carbon Fiber series oil pressure gauge ~Autometer Carbon Fiber series voltmeter ~Ichibahn brushed aluminum pedals Audio mods: ~Panasonic 7" touchscreen DVD Player as the car sits currently. http://img.photobucket.com/albums/v3...1/DSC_1927.jpg http://img.photobucket.com/albums/v3...1/DSC_1946.jpg http://img.photobucket.com/albums/v3...36_VPfkD-L.jpg http://img.photobucket.com/albums/v3...1/IMG_5786.jpg http://img.photobucket.com/albums/v3...1/DSC_1308.jpg and a few vids of the car out on course http://youtu.be/Co6G-vMFb5s not my best run of the day... only got 3 runs in before I had to park the car due to a failing wheel bearing http://youtu.be/7QtNkIx5m0A still have lots of plans for the car. currently have a new clutch, fidanza flywheel, and lsd that will be installed within the next few weeks. |
Cool. I like teh super charger.
I got kicked out of autocross twice... Next one I go to I'm running over every single cone then driving to DQ to celibrate. |
Didn't you work at Gregs shop on Rt.51...car looks very familiar
|
i love this cavy. very nice build
|
Looks great. From the vid sounds like you need to upgrade to some RS3's or Dunlop Z1's.
|
nice setup, just sucks that its 4 door
|
Quote:
|
I had no idea there was such a large aftermarket for these cars. Cool project.
|
there are a couple guys on another forum I'm on that are making over 500hp with their cavaliers.
|
couple pics of the cavalier from the last autox...
http://img.photobucket.com/albums/v3..._1370675_n.jpg http://img.photobucket.com/albums/v3...5_716673_n.jpg and my buddies sti I co-drove in the afternoon after my passenger side wheel bearing decided to fail... (luckily I was able to limp the car home) http://img.photobucket.com/albums/v3..._1672140_n.jpg |
Always liked the way your car looked and the way it was built.
|
trans is out of the car.
got the fidanza flywheel and the clutchnet 6 puck installed. hoping to tear into the tranny this week to get the obx lsd installed and get it buttoned back up and broken in for the next NEPA autox in Sept. |
Nice to see a nice cavalier.
|
just a small update...
trans out: http://img.photobucket.com/albums/v3...10825-2006.jpg clutch/flywheel out http://img.photobucket.com/albums/v3...10825-2023.jpg http://img.photobucket.com/albums/v3...10825-2023.jpg new clutch/flywheel installed http://img.photobucket.com/albums/v3...10828-2022.jpg trans is apart and the stock diff is out. gotta get the new bearings on the new diff and then i'm ready to reassemble/reinstall. did find this stuck the to magnet in the trans though... it's a bellville washer that's broken in half. now I just need to figure out where it came from... http://img.photobucket.com/albums/v3...10831-2015.jpg |
found out the broken washer goes behind one of the spider gears in the old diff so no worries there.
went to install the new diff and ended up cracking the case putting the trans back together. got the case welded up today. hoping to put the tranny back together in the car this weekend and getting the car ready for the nepa closer 10/8. |
wow... haven't updated this for a bit.
got the trans case welded and all buttoned up in time for the end of the NEPA season. the LSD changed the whole dynamic of the car. where it used to grip on entry and push on exit, it pushes on entry and tucks and grips on exit. threw some more camber in it for Sunday and the car just grips. Can't wait to get some better tires on it. I've got a set of fender cowl braces coming for the car and finally tracked down a 4th bronze wheel but other than that, not much going on. trying to take care of some debt and get back on track so the car is on the back burner at this point. I've actually have tossed around tearing the car down and doing a long term build on it using the proceeds from selling parts taken off the car that won't be used in the new build... but haven't made a definitive choice yet. and a pic or two cuz hey... who doesn't like pics http://img.photobucket.com/albums/v3...1/DSC_1917.jpg http://img.photobucket.com/albums/v3...1/DSC_1426.jpg http://img.photobucket.com/albums/v3...1/DSC_1428.jpg and some older stages of the car http://img.photobucket.com/albums/v3...1/DCP_0020.jpg http://img.photobucket.com/albums/v3...1/990f284d.jpg http://img.photobucket.com/albums/v3...1/DSC_0145.jpg http://img.photobucket.com/albums/v3...1/DSC_1280.jpg |
fender cowl braces came in...
install coming soon. http://i15.photobucket.com/albums/a3...3-17140827.jpg |
some new toys:
http://img.photobucket.com/albums/v3...1/Untitled.jpg a few progress pics... http://img.photobucket.com/albums/v3...9-28220435.jpg blower off http://img.photobucket.com/albums/v3...9-28233550.jpg old heat exchanger off http://img.photobucket.com/albums/v3...9-29001007.jpg intake manifold off http://img.photobucket.com/albums/v3...9-29003008.jpg new dual pass endplate installed http://img.photobucket.com/albums/v3...9-29005056.jpg intake mani back in with the phenolic spacer installed still have to plumb new lines for the dual pass and install the new heat exchanger/reinstall the blower |
ah the old cavalier days. i still miss the 2 i had some days. fun cars to mess around with and the parts were dirt cheap
|
sweet build!
|
All times are GMT -4. The time now is 10:35 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.