PDA

View Full Version : abs light after front bearings install


STiGuy06
04-07-2010, 09:21 PM
the ABS light came on then went off and the Brake light on the dash flickers and make a noise....any ideas? I did notice the sensor cover has a small gash in it, so i'll put electrical tape over that...but any other ideas if its not that.

TROLL
04-08-2010, 01:38 AM
wheel speed sensor... is that the sensor you're talking about? any time you're working with wheels, brakes, hubs, or in that area... there's a chance of damaging the wheel speed sensor and it can cause this. pretty common, just answered the same question for someone on supraforums yesterday.

STiGuy06
04-08-2010, 03:39 PM
Brake pad low width sensor. It says that in the write up "How-To" on Vortex... I took it to my mechanic because i've had enough haha...I miss driving it because i can't drive my STi daily, too much monies for gas.

vDevilu
04-08-2010, 04:07 PM
sounds like the wear sensors on pads. I did that changing out my springs.... There is a way to turn it off with Vag-com.