Input shaft bearing

[Keeper1343]

How hard are they to replace? I know you have to take the trans off. I just got done doing my clutch and replaced the TO Bearing and now it started to make noise after 160 miles. When the pedal is out it makes noise but if i put a slight pressure on the pedal it goes away. Could this be the shaft bearing or a bent fork? Thanks in advance

[TurboGSR96]

if you put pressure on the pedal and the squeak stops it could still be the throwout bearing, my brand new bearing still squeaked unless I rested my foot on the clutch pedal. Input shaft bearing is not that bad its right on the case, but its never smart to just change one bearing you want to change them all while you are in there.

[Keeper1343]

i figured thats all what was recommended to change. Could a bend fork cause it to make noise as well?

[driftingrx5.7]

if you know what you are doing in the trans its not hard to do, i had to replace mine on my b18b in my civic i am so happy i had a buddy with a press and knew what he was doing with the trans! its not hard as long as you know what you're doing

[Keeper1343]

good... u can do it lol