need some help!!!!!

[quickline2]

i need some help i am trying to debug why my car (95 nissan 240sx w/s14 sr20blacktop) wont run. it ran fine before i took it all apart but now it just doesnt want to idle and the idle is everywhere and the motor shakes like the timing is off. i am wondering if anyone has a ecu for a s14 sr20 blacktop that i can borrow for a couple mins to take that outta the picture. also if anyone is familiar with these motors i will pay u to come to my house and help me figure out whats wrong with it. as i said before it ran fine before i put on the fmic, bov and boost controller. i just cant figure it out

[TurboV]

it sounds dumb, but go over all your connections and wiring, make sure everything is plugged in and correctly done so. sometimes simple things are overlooked.

[93TalonEs-T]

Like above,check all the wiring and vacuum connections then check them again.I had a similiar problem that drove me crazy and it was the brake booster vac line that was unhooked.

[240_fun]

maf sensor plug on tight?
check all connection on all connectors but thats where i'd start

[quickline2]

i went over everything twice i even hooked back up the stock bov and it was better but still doesnt idle and now it wont even start im thinkng the ecu might be fried i wish i could find someone with one that i could use to test it. otherwise i will just go back over everything. also have one question when i put the bov on the hose that went from the intake to the stock bov what would i do with that? cap it off? reroute it? and could my maf have gone bad to cause this? if anyone is close to allentown and wants to come help me trouble shoot i will pay them to come here