Custom DP

[Willdue]

I need a custom Down pipe made for a 1.8T motor, but to fit into a MK3. Would need two flange's, and 2 O2 bungs.

Should only be one bend. They make them already, but there 300+$, and im not trying to spend that if I dont have to. I know you's probably need to see the mani, but the motors not in the car, so if you have to, I can remove the manifold and bring it in.

LMK!

[AREA1320]

Will,

The dp alone for us to fab would probably run you around $300. We do not used junk steel as every exhaust piece we do is stainless. Which isn't cheap. Not only that, we would have to make flanges and such. Custom one off pieces are not cheap to do. I would advise you just sucking it up and buying a pre made one ;)

Ryan

[Willdue]

Grrm have to say, i was kinda expecting that :(

I just cant see paying 300 for a little pipe lol