Fender rolling/pulling

[alwaysinboost]

looking to have the fenders rolled and or pulled to accomidate some wider wheels & tires on the EVO. can anyone suggest some good local shops?

[TROLL]

R/T Tuning and Area 1320 both do it... i know that.

[Ender81]

I've seen Area1320 do them and they do a good job.

[a2low240]

Your not going to get an insanely large pull on the EVO because the metal near the door limits you too much. Our rolling / flaring is $45 a wheel.

[alwaysinboost]

^^^ you do know the fenders on the EVO are aluminum right?

I don't need any magic done, just trying to fit some 9.5" wide rims under there. not sure on the wheel offset yet because I haven't decided which rims I'm going with.

[TROLL]

oh cool and now i know that import intelligence does rolling as well... i'll keep that in mind.

[Suckface]

^^^ you do know the fenders on the EVO are aluminum right?

I don't need any magic done, just trying to fit some 9.5" wide rims under there. not sure on the wheel offset yet because I haven't decided which rims I'm going with.

you shouldn't need to roll the fenders if you are only trying to fit 9.5" with the correct offset..........I would decide on wheel and offsets prior to rolling the fenders!

[champ_6]

where is area Area1320 located?

[Ender81]

Nazareth pm them and they will get you directions. Or you could show up at the meets on Tuesday nights at Applebee's and anyone there can tell you (Ryan from 1320 is usually there).