yellow2000S/R
10-03-2007, 09:28 PM
Figured I would try on here before I start going to local shops to support the vendors if any did this type of work. I might make them in Chassis Fab class using most likely a plasma cutter but if I could get them made elsewhere it would give me more time on other projects (AKA cutting some of the floor pan on the inner sides of my pinchwelds in the ZX2 out and some of the rear floor / trunk pan out in prep for the Mustang Cobra IRS in the future and framing it all with probably 2"x3" .120 + box tubing.
I would like an estimate for the following (can be via PM if you do not want to disclose the price in public).
The order would be for 30 of the following pieces cut from 3/16" flat stock or whatever. I drew them up in SolidWorks 2007 but I'm sure some stuff might be off b/c I just got the program yesterday and taught myself.
The measurements are in MM. The center points for the 12mm holes are 96mm apart and completely square with each other.
http://www.endlessmotorsports.net/Gallery/EndlessMotorsportsPARTS/ZX2StrutBar/P1.jpg
http://www.endlessmotorsports.net/Gallery/EndlessMotorsportsPARTS/ZX2StrutBar/P2.jpg
I would like an estimate for the following (can be via PM if you do not want to disclose the price in public).
The order would be for 30 of the following pieces cut from 3/16" flat stock or whatever. I drew them up in SolidWorks 2007 but I'm sure some stuff might be off b/c I just got the program yesterday and taught myself.
The measurements are in MM. The center points for the 12mm holes are 96mm apart and completely square with each other.
http://www.endlessmotorsports.net/Gallery/EndlessMotorsportsPARTS/ZX2StrutBar/P1.jpg
http://www.endlessmotorsports.net/Gallery/EndlessMotorsportsPARTS/ZX2StrutBar/P2.jpg