STi V2 engine

[peteyturbo]

Figured someone may want this..It is a few months old but may still be avail..
http://www.specialstage.com/classifieds/showproduct.php?product=86&cat=18

[teh DIRT]

good find! someone pick this up asap. i would if i had the cash!

This motor is sick! i know for a fact that it has piston squirters and a fully closed deck. Piston squirters allow piston temps to drop as low as 250*. that temp drop can give your pistons up to 50% more strength.

you can have this wired in for unde 1k probably.

so say 2k= 260hp stock.

[2slowMX5]

nice.

[Renegade_]

um, holy **** that is basically exactly what I am looking for - now I gotta make sure they give you wiring, ecu, etc - how can I get in touch with em and where are they located?

*edit* All over that ****, PM sent. Gotta find out where the motor is though.

[jkjersey]

Just keep in mind that when you do engine swaps it looks cheaper in the beginning than when you are knees deep in it. I just got the invoice on for my conversion and it was a couple thousand more than I anticipated. All of the upgrades or modifications that they performed to my GC8 were valid too.

The posting says August 2006. I doubt this engine is still for sale. If the compression on the engine was on point though it was a good deal.
----------------------------------------------------------------
http://img.photobucket.com/albums/v420/Teckademics/Teck%201%20pics/teck5dh.gif
http://www.infinitenetworks.org/_JayK/pics/myspace/mrhappy.jpg
http://www.infinitenetworks.org/_JayK/pics/myspace/comments/creepmastah_approved_r.gif

Impreza GC8 JDM STI VI conversion
05 MCS

Drop by my page @ http://www.myspace.com/jkjersey

[Renegade_]

Just keep in mind that when you do engine swaps it looks cheaper in the beginning than when you are knees deep in it. I just got the invoice on for my conversion and it was a couple thousand more than I anticipated. All of the upgrades or modifications that they performed to my GC8 were valid too.
I would be swapping the motor, not someone else. I dont care how long it takes, if I have both diagrams it will get done. I have the USDM pinouts but I can't write an all out chart yet because it has not yet been confirmed as to what motor I would buy and version matters on some of the pinouts. (albeit it would be an older v2/3 motor, preferably EJ20G closed deck)

*edit* And why the hell did you paste all that stuff in your post - its annoying as hell

[peteyturbo]

cool, I hope one of you guys end up with it..