PDA

View Full Version : Any DSMer out there looking for a 7 bolt 4G63 block?

boneheadperformance
05-10-2005, 11:20 PM
We have one laying around and looking to get rid of it. $50 takes it. Local pick up only.
gtsiawd96
05-10-2005, 11:28 PM
me too crankwalked -- free to good home
boneheadperformance
05-11-2005, 07:07 AM
This block is actually free of crank walk. Just had it laying around because the customer swapped a 6 bolt in his 2G instead of keeping the original 7 bolt.
Jeffros Spec V
05-12-2005, 01:03 AM
me too crankwalked -- free to good home


Can I have it for free? Seriously?
gtsiawd96
05-12-2005, 01:13 AM
I swear to god get it out of my garage... Its a bare block. Block, crank, girdle, no pan, no rods, no pistons. Theres are a couple other little things i have lying around to.
Jeffros Spec V
05-12-2005, 01:22 AM
SIC, I want it

I'll pick it up tomorrow if you want.


I swear to god get it out of my garage... Its a bare block. Block, crank, girdle, no pan, no rods, no pistons. Theres are a couple other little things i have lying around to.
gtsiawd96
05-12-2005, 01:27 AM
i'm at school in west chester. I'll be home where the motor is in a couple days most likely. I'll let you know when i will be home.
Jeffros Spec V
05-12-2005, 01:32 AM
Alright sounds good...


Chuck, sorry to ruin your thread.
boneheadperformance
05-12-2005, 07:00 AM
Its cool. You will have to take it to a machine shop to get it right since it had crank walk. It might never run again. :(
Jeffros Spec V
05-12-2005, 08:53 AM
Its cool. You will have to take it to a machine shop to get it right since it had crank walk. It might never run again. :(

Not worried about that.
gtsiawd96
05-12-2005, 11:14 AM
Its cool. You will have to take it to a machine shop to get it right since it had crank walk. It might never run again. :(

most def.
ixlr811s
05-14-2005, 06:33 PM
It can run again.... if you have a machinist place a nice weld all the way around the crank, on the center thrust journal, then machine to specs, it will actually be alot stronger than an oem crank. The nickel in the weld is alot stronger than the casting that the crank is made from. Just a little FYI.... I didn't know that until a machinist told me about that.
noreaga0221
05-16-2005, 09:42 PM
Since theres 7 bolts being given away i'll throw in my deal..

4g64 from a spyder, block crank and oil pan. Best offer. Crank needs to be polished, did not crank walk. Someone take it!
tripod
02-19-2007, 11:39 AM
noreaga how much were you lookin to get for the 4g64 block, crank, and pan. i need to rebuild my motor asap.