Bypass Valve gasket

[JoeScooby]

What holds that sucker on? I went to change it this morning and I couldnt get the old one off, I peeled half a corner off and it looked like some sticky residue was left over. I pushed it back down before I ruined whatever was left... didnt have a clue if I needed some sort of sealant or anything.

[SpendOne]

Razor blade the old one off, then get the rest off with some sand paper. Use RTV, unless there is some kind of sealant on the new gasket from factory.

[JoeScooby]

Thanks! Will high temp RTV do ok?

[SpendOne]

Yea only apply a thin layer, or use the copper spray.

[2point4DSM]

Ultra grey is the best. Orange is too soft.

[karl]

u dont need sealent! just get the gasket. the one on there just needs to be pealed off! ill help ya if u want

[JoeScooby]

Im done... took a few minutes.. thanks for the offer!@!~